Introduction to cold heading machine.

1. Check that the knife plate, cutting knife bar, punch, die, etc. should be intact without cracks, installed correctly, and fastened firmly.

2. After adjusting the cutting mechanism, the clearance between the cutting mechanism and the die holder must be checked. It is strictly forbidden to start the equipment without checking.

3. When the cutter bar has been folded, the roller in the cam groove must be taken out before the equipment can be jogged.

4. When starting the equipment, the main motor can be started to drive the flywheel to rotate only when the feeding device is disconnected. Do not switch on the feeder until the flywheel is at full speed. When stopping the equipment, disconnect the feeding device first, and then stop the main motor.

5、不准将滑块停在死点的位置上，如滑块停在死点上时，只准用人工盘动飞轮的方法来纠正，不准开动设备。在切料刀杆已折的情况下，必须把凸轮槽中的滚轮取出后，方要点动设备。

6、经常注意盘料架的工作情况，发现混乱应立即停车。盘料加工到快完时，应将料尾从盘架上脱出。